Thursday, October 11, 2007

How To Stretch a Canvas for Painting

There are respective options for an creative person today. Pre-stretched canvases are available in many sizes in most fine art supply stores. But there are modern times when an creative person may wish to stretch along their ain canvases.

Begin with the frame. Some people like to utilize precut framework lengths that have got a adjustment lingua on each end. You will necessitate two braces of wood (four pieces) per frame. For a 16 x 20 frame, for example, you will necessitate two 16" lengths and two 20" lengths. Fit 1 corner together of a long and short length and tap together with a mallet. Continue with the other pieces alternating long and short. Use a T-square or a Right-angle trigon to do certain you have got hammered together a rectangle and not a trapezoid. If your framework is not in alignment, gently squash the two corners furthest away from each other until they are square.

To do a framework using uncut wood lengths you will necessitate a wood saw and a mitre box, or a chop up mitre saw. You will also desire a heavy duty basic gun or Volt type nails made specifically for joining together two pieces of wood. You will be cutting two braces of wood lengths. All eight ends will be cut at a 45 grade angle with the mitre equipment. The longer border of each piece will constitute the outer dimensions of your frame. After you have got cut your pieces, set together a long and a short length and fall in with one basic or joining nail. Check that you have got a right angle. If desired, you can clamp the wood pieces to a right angle (such as a block of wood) to help you while you fall in it. Continue with the other corners, and give a concluding bank check for right angles.

You are now ready to stretch along the canvass over your frame. You will necessitate a visible light weight basic gun or tacks and a hammer, and creative person class canvas. Cut your canvass in a rectangle with an other 2" or more than on all sides of the frame, enough to draw the canvass around to the dorsum of the frame. Topographic Point the canvass on the flooring or tabular array human face down with the framework centered on it. Pull up one side of the canvass and attach with one basic or tack only, in the center of that side on the back. Now gently draw the antonym side, and pulling so that there is no slump but it is not stretched tight, attach that canvass to the center of the back.

Now travel to the sides that are not yet done. Take one side and gently draw it to the center of the dorsum and attach. Avoid puckering the canvas. Take the center of the 4th side and draw so that the canvass is like the top of a drum. You desire neither too tight nor too loose. After this side is attached, start adding one basic or tack to each side, about 1 - 2 ins apart, continuing in a circle around the sides. Work your manner towards the corners from the centers of each side. When you acquire close to the corners, neatly fold up the corner. This is done much like "a infirmary corner" on a bed sheet. Secure corners and your canvass is now ready for priming and painting.

No comments: